Starflow (6526)

• How long will Starflow hold its memory (collected data) for after power is disconected?
• How do I log AVE depth?
• How long will my battery last?
• Why won't my Starlow record velocity?
• How to setup the UDI so it shows positive and negative flows.
• Why are the recorded values exactly half of what is shown on the FTU?
• What does the message "error 5: pdlint, parity error" mean?

Starloggers

• Which Terminal on the Starlogger Field Termination Strip is used for external power input?
• Is the 6004C compatible with a serial to USB convertor?
• Why do both battery LEDs on my Starlogger remain on constantly?
• Why do I get the message "Firmware Incorrect" when programming my Starlogger?
• Does the Starlogger have 16-bit analog inputs?
• How do I use the open collector output?
• I have forgotten the keypad pin number, how do I reset it?
• Why don't the status LEDs flash at all?
• Does the Starlogger support SDI-12?

Batteries

• Why don't you fit a battery holder so I can use normal batteries instead of having to buy a new battery pack?

Software

• How can we convert a lotus file to an ascii file?
• What alterations are needed in order to use thermistors other than standard Unidata thermistors?
• How can I get the software to run a model 6004C Starlogger?

Prologgers

• If the differential between two inputs is less than 50mV can I select this as the range even if the actual voltages are around 2500mV?
• What resolution are the analog inputs?
• Why are some data readings wrong when I use my prologger with an external power source?
• How do you configure the V3 software to use differential input?
• How can I clean corrosion from the circuit board?

Macro loggers

• How do I configure a Macro logger with V3 software?

8007WDP

• How does the DWLR work?

Miscellaneous

• How do I calibrate the temperature on a model 6508 depth probe?
• Do I need to calibrate your barometer when using it at different altitudes?